2011 PEUGEOT 3008 brake pad replaced method by Launch x431

2011 PEUGEOT 3008 brake pad replaced method by Launch X431

Operation Method: 

1. Switch on the ignition, not start the engine;

2.Select brake pad reset software V10.20 above; 3.Select“PEUGEOT”;

4. Select“Auto-Scan”or the “Manual Selection”;

5. Select “3008”;

6.Prompt to turn on the ignition, then “Prompt for communication, please wait …”, display the percentage, display after completion

Warning message, as shown in Figure 1;

7.Select “Yes” button to display the menu, as shown in Figure 2;

8.Select “brake wire replacement” menu, prompt information, as shown in Figure 3;

9.Select “Yes” button to display the menu, as shown in Figure 4;


10.Select “placed in the installation / removal position” menu, prompt information, as shown in Figure 5;

11.Select “wire tensioning” menu, prompts to turn off the ignition switch, turn on the ignition switch information, turn on the ignition switch, the wire tensioning function is completed, as shown in Figure 6;

12.Select “Electronic Parking Brake Calibration” menu, prompt information, select “OK” button, as shown in Figure 7;

13.Countdown 15s, as shown in Figure 8;

14.Countdown 15s, prompt information, as shown in Figure 9;

15.Select the “OK” button, and it will prompt “The electronic parking brake wire calibration is complete”, click “OK” to finish, as shown in Figure 10;

16.Return to the previous menu, select “Electronic parking brake replacement” menu, prompt information, as shown in Figure 11;

17.Select “Yes” button, display “placed in the installation / removal position”, “tighten the wire,” “Electrical parking brake calibration” menu, select “placed in the installation / removal position” menu, prompt information, as shown in Figure 12;

18.The “wire tensioning” and “Electrical Parking Brake Calibration” functions are the same as the “wire tensioning” and “Electrical Parking Brake Calibration” function operations in the “Brake Wire Replacement” function, and will not be repeated here.

Cnautotool