1. Drain the oil when the engine is warm as contaminants held in suspension will then be drained with the oil. Park the machine on firm ground.<\/p>\n
WARNING!
\nMake the machine safe before getting beneath it. Lower the attachments to the ground; engage the parking brake; remove the starter key, disconnect the battery.<\/p>\n
JCB Service Master 4 v22.9.3 [10.2022] Diagnostic Software Download<\/a><\/p>\n 2. Make sure the park brake is engaged and the transmission set to neutral. Lower the loader arms and 3. Open the bonnet, see Engine Panels, Opening and Closing the Bonnet.<\/p>\n 4 Drain the oil: JCB Agco SISU Power WinEEM4 \u2013 JCB Service Tool 2.8.0<\/p>\n 5. Change the filter: 6. Fill the engine to the max mark on the dipstick with new oil through the filler. See Service Capacities and Lubricants for recommended oil grades. Wipe off any spilt oil. Check for leaks. Make sure the filler cap is correctly refitted.<\/p>\n 7. Make sure the engine will not start and turn the starter switch to operate the starter motor until the oil pressure light is extinguished. (To make sure the engine will not start, remove the engine shut-off solenoid fuse, housed in the fuse box).<\/p>\n 8. Insert the engine shut-off solenoid fuse and operate the engine. Check for leaks. When the engine has cooled, check the oil level<\/p>\n","protected":false},"excerpt":{"rendered":" This article mainly introduces JCB Loader Changing the Oil and Filter Setup 2022 JCB Heavy Duty Truck Diagnostic TOOL JCB Electronic Service tool with JCB Service Master 4 V1.73.3 or V22.7.2 1. Drain the oil when the engine is warm… Continue Reading ![\"\"](\"https:\/\/www.cnautotool.com\/blog\/wp-content\/uploads\/2022\/12\/JCB-Loader-Changing-the-Oil-and-Filter-Setup-1.png\")
<\/a><\/p>\n![\"\"](\"https:\/\/www.cnautotool.com\/blog\/wp-content\/uploads\/2022\/12\/JCB-Loader-Changing-the-Oil-and-Filter-Setup-2.png\")
<\/a><\/p>\n
\nbackhoe to the ground, switch OFF the engine and remove the starter key.<\/p>\n
\nCAUTION!
\nOil will gush from the hole when the drain plug is removed. Hot oil and engine components can burn you. Keep to one side when you remove the plug.
\n13-3-1-15
\na Place a container of suitable size beneath the drain plug.
\nb Remove drain plug C and its \u2018O\u2019 ring. Let the oil drain out, then clean and refit the drain plug with a new \u2018O\u2019 ring. Tighten to 34 Nm (25 lbf ft).<\/p>\n
\na Unscrew the filter canister D. Remember that it will be full of oil.
\nb Check that adapter G is secure.
\nc Clean the filter head F.
\nd Add clean engine lubricating oil to the new filter canister. Allow enough time for the oil to pass through the filter element.
\ne Smear the seal E on the new filter with oil. Screw in the new filter canister \u2013 hand tight only.<\/p>\n