How Use CAT ET to Check the Programming of the Parameter Dedicated PTO Parameters

PTO Configuration Test: Cab Switches (using Caterpillar ET Software) Cab Switches 1). Use CAT ET to Check the Programming of the Parameter Dedicated PTO Parameters. →Connect CAT ET to the data link connector. Read More: How to Connecting Caterpillar ET… Continue Reading

Real Time Graphing using Caterpillar ET Software

Real Time Graphing using Caterpillar ET Software #Purpose Real Time Graphing monitors ECM data and displays it in graphical form as it occurs. When running Real Time Graphing for the first time, a set of parameters must be selected to… Continue Reading

How to Remote Switches by Caterpillar ET Software

How to Remote Switches by Caterpillar ET Software 1). Use CAT ET to Check the Programming of the Parameter Dedicated PTO Parameters. →Connect CAT ET to the data link connector. Read More: How to Connecting Caterpillar ET Software to the… Continue Reading

Free download 2021.3 Xentry for MB SD C4 C5 Software

We share the free link for download xentry 2021.3 xentry software download link: https://share.weiyun.com/d9D1ht4V, password: fmochy Size: 19.96GB Notice: This link is xentry Software only, if you need the whole software, you can buy the hdd from us. MB SD… Continue Reading

Start/Run/Stop Switch on Caterpillar ET Software

Start/Run/Stop Switch on Caterpillar ET Software Start/Run/Stop Switch The Electronic Control Module (ECM) receives two input signals from the Start/Run/Stop Switch. The two input signals should have the same logic level. If two different signals are detected during the powerup,… Continue Reading

Shut Off Solenoid Test using Caterpillar ET Software

Shut Off Solenoid Test using Caterpillar ET Software Shut Off Solenoid Test Special Tests #Purpose: The Special Tests function allows a specific diagnostic test to be selected so that it may be triggered. The tests that appear in the list… Continue Reading

How to use Data Log Recorder on Caterpillar ET Software

Using Data Log Recorder on Caterpillar ET Software Data Log Recorder #Instructions: To use Data Log Recorder: (1). Open CAT ET and connect to the ECM. Read More: How to Connecting Caterpillar ET Software to the ECM. (2). Select Data… Continue Reading

A customer’s experience with Witech system installation

I thought i would add a small snippet of info regarding my experience with the Witech system setup. Package showed up, and it had the interface dongle, usb cable, and software disk. I made a backup of the disk and… Continue Reading

Caterpillar Engine Overspeed Program by CAT ET

This instruction show you guide on how to use Caterpillar ET diagnostic software to do overspeed programming for Caterpillar engine. Procedures: Connect CAT3 adapter to diagnostic port,then run CAT ET diagnostic software Select “Service”–>”Monitoring System” Select “Engine Overspeed” Change “Trip… Continue Reading