Allscanner VXDIAG Benz C6 multi tool released new firmware and driver update in September 2020. With the new update you can use the latest V2020.09 Xentry XODS software with the C6 multiplexer. How to Update VXDIAG Benz firmware? After install… Continue Reading
Please be informed: VXDIAG Benz C6 XENTRY EPC & WIS must be activated before using. And the following post is about VXDIAG Benz XENTRY EPC WIS Software activation. Now, please read it carefully. Turn on “Xentry License”>> “OK”. Turn on… Continue Reading
I have seen a few people struggling with DoIP and VXDIAG C6. Please see the attached image of the interface settings for DoIP. When using DoIP with Vxdiag make sure you uncheck/turn off the CAN interface(MODULE_TYPE_ID_MTS6532) in DTS. Then connect… Continue Reading
How to export HU05 control module data and program by VXDIAG Benz C6 with DTS Monaco software? Check the step-by-step guide in this post. Connect Star C6 with the vehicle Run DTS Monaco software HU5 Ethernet option cannot be found… Continue Reading
I have been using a VXDIAG Benz C6 (the new one with the LAN port and mini-USB jack) for sometime (I have the Xentry and ODIS licence). From my experience, I can tell you it’s a good device for Xentry.… Continue Reading
As titled, some people may ask if the vxdiag benz c6 doip interface DTS Monaco software requires activation. No. DTS Software does not require activation and ready to use. Why all options are gray out? There are 2 possible reasons:… Continue Reading
VXDIAG XENTRY Diagnosis VCI is the latest interface for For Mercedes & SMART vehicles can replace Star C4/C5. VXDIAG For XENTRY Diagnosis VCI acts as a Pass-through Interface, also called Star C6, For Benz C6 multiplexer to provide complete communication between… Continue Reading