How to Program Parameter for Perkins 2806C-E16 ECM

Posted on by Cnautotool

In this instruction,it show you guide on simple parameters programming by Perkins EST diagnostic software for Perkins 2806C-E16 engine ECM.

Procedures:

Note:It is test by demo mode

Select “Governor Maximum Stability Factor #1” and click “Change” button to input new value



Select “Engine Acceleration Rate”,click “Change” button



Just like the procedure show as above to perform.


Readers who read this article also read:

  1. FREE Setting EST-2018A (Genset Only), Electronic Service Tool for PERKINS Engines
  2. FREE Setting EST-2016C Full Support, Electronic Service Tool for PERKINS Engines
  3. FREE Setting EST-2018A v1.0 (JLCG2109 – Genset Only), Electronic Service Tool for PERKINS Engines
  4. AUTEL MAXISYS ULTRA Description

Cnautotool

More Posts